Inflatable Slide Installation Method

1: First, if conditions permit, the best on the ground to place a mattress (such as carpet, plastic color of the cloth may be), then the inflatable products facilities in the top flat rolled out to wait for inflation.

2: Locate the air inlet of the inflatable products, stroking along, to ensure the normal air intake out of the wind, then the fan outlet and pneumatic equipment air inlet phase, and the fan port and facilities for the port to connect properly tied.

3: Then, detect whether the fan is normal, inflatable product is folded at.

4: Finally, the products supporting the fan power, the equipment will be a few minutes after the inflatable product to charge up.

Installation of fan support:First, the number of meters to use the normal standard home cable, connecting with fans, the other end of the air switch and connected to an electric shock protector.

Then, the detection power, voltage and fan are consistent with the correct direction of rotation of the preparatory work.

Finally, the chassis on a ground, and regularly check the air inlet of the fan on the protective net to avoid accidents. Blow into.

Attached to: inflatable toys Cautions

Please ensure that in normal use, the normal power supply, fan.

To replace the power supply or turn off the fan, make sure that children from the inflatable product has been completely evacuated.

Waterfront or other windy areas, the use of such products, your own products fixed on the ground.

Use, be sure to ground smooth, no sharp or hard protrusions.

Shall be paved with a protective layer on the ground, you can use the market for the sale of the color of the cloth.

During product use, there may be stains products available to take a bath essence for cleaning. Cleaning with a soft towel, not with a stiff brush.

When unused for long periods, keep the jumping bed to dry, and put in a cool dry at.

By rain in the course, the first time to open the product, with fans blowing, the remaining fans mouth open, the internal water vapor to disperse, and make the appropriate drying.

The product is a high-speed industrial sewing machines, sewing, sealing products, you need to pinhole has been running a continuous air supply air fan, we can achieve the effect of bounce, so the product leak, run gas do not have to worry about is a normal phenomenon.